Horizontal ‘Slider’ Window Insect Screens normally covers the half of the window that opens.
Measuring the Window Screen “Width”
- Check for U-Shaped Channels on the left and right sides.
- You should find that one of the channels are deeper than the other.
- The deep side is normally at the center of the window (right side) and is 1/4″ to 1/2″ deep.
- The opposite side channel is usually only about 1/16″ to 3/16″ deep.
- We call the Deep Side a ‘Channel’ and the Shallow Side a ‘Lip’.
Put the end of a metal measuring tape all the way into the deepest channel and hold it as straight across as possible.
IMPORTANT: The hook on the metal tape must be small enough to go into the channel.
- Make sure the measuring tape is all the way into the deepest Channel.
- You should measure the opposite side 1/16″-1/8″ short of the ‘Inside Edge’ of the Lip.
- Provide measurements to the nearest 1/16″.
- This measurement is your window screen ‘Width’.
IMPORTANT: The concept is that when you insert the insect screen in the deepest channel, it has to be short enough to clear the edge of the other side lip, then the springs push the screen into place in the shallow side channel.
Measuring the Window Screen “Height”
Put the end of a metal measuring tape from top to bottom and hold it as straight as possible.
IMPORTANT: The top and bottom should just be a L-Shape recessed area. You cannot insert a window screen into U-Shaped Channels on more than two opposing sides.
- Place measuring top against top L-Shaped recess.
- Measure to the bottom L-Shaped recess and Subtract about 1/8 inch.
- Do not measure the tolerance too tight to allow easy insertion and removal.
- Provide measurements to the nearest 1/16″.
- This measurement is your window screen ‘Height’.
Your Window Screen “Hardware”
The typical Hardware used on these type of window screens are:
Tension or Leaf Springs on One Side,
Lift Tabs on Opposite Side
These Hardware Options are found on our Custom Window Screens order Pages:
Installing your Slider Type Window Screen
First, insert the side of the window screen with the springs into the deepest channel enough to compress the springs.
Then slip the opposite side of the screen into the shallow channel behind the lip. The springs should push the screen left to hold it in place.
Quality Screen Co. Offer These “How To” Guides to Provide Some Guidance and Tips on Various Activities Related to Measuring, Ordering or Installing Window &Door Screens, Porch & Patio Screening Systems and Other Do-It-Yourself Screening Projects. Remember That We Cannot See Your Windows or Doors and That You Are Responsible For Determining Your Own Specific Needs. If the How To Guides Do Not Seem to Describe Your Project or You Do Not Understand Them, Feel Free to Contact us.
